0

How do I have the optimisation layouts treat the edging thickness as zero?

I would like to set the actual finished size of the panel on the printout.
Currently if I set the panel size to 1000mm x 1200mm and include 2mm edging, the printout shows 1096mm x 1196mm. The production system I am using trims 2mm off of the board when placing the edging.
So in order to prevent confusion in production, I would prefer to show the cut size as 1000mm x 1200mm with the dashed lines where edging goes, as some sides may also have different thickness edging.

How do I set this for the printout Job Layout?

2 comments

Please sign in to leave a comment.